Statics Design Project

Statics De trait Project Third Design Project University of Wisconsin - majuscule of Wisconsin Abstract For this formula project I was required to formulate a shaft for a water turbine that must check out power to an electric generator and also to a range elevator for carrying grain to a hopper while show kill the criteria given to me by my boss. I was given some sign values and am supposed to place two bearings B and D to support the shaft to meet the criteria given. Design Criteria Shown down the stairs is the diagram I was given to find the place of bearings B and D.

I w as given that the total bending thin on the shaft at the sprocket C is 815 lb, and the control status of the chain is oriented at an angle of 40 deg from the vertical. At gear E, Which drives the generator, the bending forces on the shaft ar 494lb in the y-direction, and 180lb in the x-direction. Also the flat whang pulley block A which drives the elevator, the maximum allowable tension in the smash is 417lb. The belt will be par...If you want to get a plentiful essay, order it on our website: OrderCustomPaper.com

If you want to get a full essay, visit our page: write my paper